summaryrefslogtreecommitdiff
diff options
context:
space:
mode:
-rw-r--r--microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn6
1 files changed, 4 insertions, 2 deletions
diff --git a/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn b/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn
index 09c9fa15..aa432250 100644
--- a/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn
+++ b/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn
@@ -77,6 +77,8 @@ These boards are known to work. Gnumach/Hurd has been installed and run on these
These boards or hardware combination are known to fail with gnumach/Hurd.
-* ASUS P5A motherboard and AMD K6-2 333MHz CPU - Debian GNU/Hurd will install but not boot on this board
+Note: The Debian GNU/Hurd installer actually runs on Linux, so it (almost) always works. The critical bit is booting after installation.
+
+* ASUS P5A motherboard and AMD K6-2 333MHz CPU - doesn't boot
* ASUS P2B-LS motherboard with an Intel PII-MMX 400 MHz CPU - this board had a defective onboard NIC (that could not be disable in BIOS) and working 3COM Etherlink III NIC in a PCI bus slot. This combination worked with GNU/Linux. The 3COM NIC is known to work with the Hurd. However, while gnumach/Hurd will boot on this system, it is confused by the defective onboard NIC and unable to use the 3COM NIC. Attempting to start networking generates a continous stream of eth0 and eth1 reset messages on the console that renders the system unusable.
-* ASrock 775Twins-HDTV with a Pentium D 810 (533 MGz FSB/2600GHz core -- information no longer present on intel's site). Installs but does not boot.
+* ASrock 775Twins-HDTV with a Pentium D 810 (533 MGz FSB/2600GHz core -- information no longer present on intel's site). Doesn't boot.