From 0ab9ef8ab8c57ab83cb01bef37ca6d30395a43a2 Mon Sep 17 00:00:00 2001
From: Justus Winter <4winter@informatik.uni-hamburg.de>
Date: Mon, 9 Jun 2014 18:33:30 +0200
Subject: doc: explain the floating point flag in kdb output

* doc/mach.texi (Kernel Debugger Commands): Explain the floating point
flag.
---
 doc/mach.texi | 5 +++--
 1 file changed, 3 insertions(+), 2 deletions(-)

(limited to 'doc/mach.texi')

diff --git a/doc/mach.texi b/doc/mach.texi
index 49c0d67..2da670f 100644
--- a/doc/mach.texi
+++ b/doc/mach.texi
@@ -7029,8 +7029,9 @@ session.  If the execution is resumed again, the numbers may change.
 The current thread can be distinguished from others by a @code{#} after
 the thread id instead of @code{:}.  Without @code{l} option, it only
 shows thread id, thread structure address and the status for each
-thread.  The status consists of 5 letters, R(run), W(wait), S(suspended),
-O(swapped out) and N(interruptible), and if corresponding
+thread.  The status consists of 6 letters, R(run), W(wait), S(suspended),
+O(swapped out), N(interruptible), and F(loating) point arithmetic used (if
+supported by the platform). If the corresponding
 status bit is off, @code{.}  is printed instead.  If @code{l} option is
 specified, more detail information is printed for each thread.
 
-- 
cgit v1.2.3