diff options
Diffstat (limited to 'microkernel/mach/gnumach')
| -rw-r--r-- | microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn | 6 |
1 files changed, 4 insertions, 2 deletions
diff --git a/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn b/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn index 09c9fa15..aa432250 100644 --- a/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn +++ b/microkernel/mach/gnumach/hardwarecompatibilitylist.mdwn @@ -77,6 +77,8 @@ These boards are known to work. Gnumach/Hurd has been installed and run on these These boards or hardware combination are known to fail with gnumach/Hurd. -* ASUS P5A motherboard and AMD K6-2 333MHz CPU - Debian GNU/Hurd will install but not boot on this board +Note: The Debian GNU/Hurd installer actually runs on Linux, so it (almost) always works. The critical bit is booting after installation. + +* ASUS P5A motherboard and AMD K6-2 333MHz CPU - doesn't boot * ASUS P2B-LS motherboard with an Intel PII-MMX 400 MHz CPU - this board had a defective onboard NIC (that could not be disable in BIOS) and working 3COM Etherlink III NIC in a PCI bus slot. This combination worked with GNU/Linux. The 3COM NIC is known to work with the Hurd. However, while gnumach/Hurd will boot on this system, it is confused by the defective onboard NIC and unable to use the 3COM NIC. Attempting to start networking generates a continous stream of eth0 and eth1 reset messages on the console that renders the system unusable. -* ASrock 775Twins-HDTV with a Pentium D 810 (533 MGz FSB/2600GHz core -- information no longer present on intel's site). Installs but does not boot. +* ASrock 775Twins-HDTV with a Pentium D 810 (533 MGz FSB/2600GHz core -- information no longer present on intel's site). Doesn't boot. |